Using Release firmware 3.2.

Standard Base setup -- a Facet connected to WiFi with casting to a local NTRIP Server (SNIP). I turn it on, the Facet starts Casting, SNIP sees them, all good.

If I remove the WiFI network, then put it back, leaving the Facet on, the serial terminal shows that the Facet reconnected to Wi-Fi, but the Facet never goes back into "Casting" mode.

On the good side, if I remove just the NTRIP Server and then put it back (using SNIP, I just closed it and reopened it), after a few minutes, the Facet does start Casting again to SNIP.

I would expect that the Facet would attempt Casting again after reconnecting to a Wi-Fi network.